How Do I Test My Dishwasher Control Board
How Do I Test My Dishwasher Control Board. Try the following procedure to run a dishwasher diagnostic test: If successful then all the lights on the panel should illuminate and you can commence the test by pressing start.
If the motor relay is separate from the control board or if you have a motor relay the motor can be tested with a test cord and some jumpers. The usual method to check the control board is to try and enter a diagnostic test cycle. Make sure all other connections are made.
Plug In Dishwasher Or Reconnect Power.
Can you see the underside of the board to see the solder and circuitry? Unplug dishwasher or disconnect power. Open console and disconnect the keypad ribbon connection from the control (at p1).
Press Start And A Test Cycle Should Then Begin Which Should Cycle Through The Various Functions Of The Dishwasher.
If it is flashing 6 times in 3 seconds, hold the start and heated dry buttons for 5 seconds. If the dishwasher will fill and drain then i suspect the door switch is okay. How do you run a diagnostic test on a bosch dishwasher?
I Think The Motor Relay Is Built Into The Control Board On Your Model So It Sounds Like The Control Board Is Faulty.
Unplug dishwasher or disconnect power. What is the dishwasher not doing, out of curiousity? Your dishwasher should now be ready for use.
The Actual Setting Will Depend Upon The Make But Is The Highest Setting You Can Choose For The Washing Cycle.
Open console and disconnect the keypad ribbon connection from the control (at p1). Try a diagnostic test to check the control. How do i test a whirlpool dishwasher control board?
To Determine If The Control Or Keypad Is Faulty, Do The Following Test:
Open console and disconnect the keypad ribbon connection from the control (at p1). The usual method to check the control board is to try and enter a diagnostic test cycle. How do i test a whirlpool dishwasher control board?
Post a Comment for "How Do I Test My Dishwasher Control Board"